Hi Abu,

I think Jeff means that you should run your experiment with more iterations in order to get a stable results.
- Increase the iteration of for loop in each execution (I think osu benchmark allows you to set it)
- Run the experiments 10 or 100 times, and take the average and standard deviation.

If you see a very small standard deviation (e.g., <=5%), then the trend is stable and you might not see such gaps.

Best regards,
Min
On 2018/06/20 12:14, Abu Naser wrote:

Hello Jeff,


Yes, I am using a switch and other machines are also connected with that switch.

If I remove other machines and just use my two node with the switch, then will it improve the performance by 200 ~ 400 iterations?

Meanwhile I will give a try with a single dedicated cable.


Thank you.


Best Regards,

Abu Naser

From: Jeff Hammond <jeff.science@gmail.com>
Sent: Wednesday, June 20, 2018 12:52:06 PM
To: MPICH
Subject: Re: [mpich-discuss] osu_latency test: why 8KB takes less time than 4KB and 2KB takes less time than 1KB?
 
Is the ethernet connection a single dedicated cable between the two machines or are you running through a switch that handles other traffic?

My best guess is that this is noise and that you may be able to avoid it by running a very long time, e.g. 10000 iterations.

Jeff

On Wed, Jun 20, 2018 at 6:53 AM, Abu Naser <an16e@my.fsu.edu> wrote:


Good day to all,


I had run point to point osu_latency test in two nodes for 200 times.  Followings are the average time in microsecond for various size of the messages -

1KB    84.8514 us
2KB    73.52535 us
4KB    272.55275 us
8KB    234.86385 us
16KB    288.88 us
32KB    523.3725 us
64KB    910.4025 us


From the above looks like, 2KB message has less latency than 1 KB and 8KB has less latency than 4KB.

I was looking for explanation of this behavior  but did not get any.


  1. MPIR_CVAR_CH3_EAGER_MAX_MSG_SIZE is set to 128KB. So none of the above message size is using Rendezvous protocol. Is there any partition inside eager protocol (e.g. 0 - 512 bytes, 1KB - 8KB, 16KB - 64KB)? If yes then what are the boundaries for them? Can I log them with debug-event-logging?


Setup I am using:

- two nodes has intel core i7, one with 16gb memory another one 8gb

- mpich 3.2.1, configured and build to use nemesis tcp

- 1gb Ethernet connection

- NFS is using for sharing

- osu_latency : uses MPI_Send and MPI_Recv

- MPIR_CVAR_CH3_EAGER_MAX_MSG_SIZE= 131072 (128KB)


Can anyone help me on that? Thanks in advance.




Best Regards,

Abu Naser


_______________________________________________
discuss mailing list     discuss@mpich.org
To manage subscription options or unsubscribe:
https://lists.mpich.org/mailman/listinfo/discuss




--
Jeff Hammond
jeff.science@gmail.com
http://jeffhammond.github.io/


_______________________________________________
discuss mailing list     discuss@mpich.org
To manage subscription options or unsubscribe:
https://lists.mpich.org/mailman/listinfo/discuss