3 Jun
2021
3 Jun
'21
1:54 p.m.
It's a type of special filter: test: filter: Error: true If you look in `src/sys/tests` there are a couple examples of this. The `Error:` enables the ignoring of the error code. Scott On 2021-06-03 09:54, Jacob Faibussowitsch did write:
Hello All,
All of our unit tests look for some kind of positive result, but is there any established way in the harness to test for failure of a particular kind?
Best regards,
Jacob Faibussowitsch (Jacob Fai - booss - oh - vitch)
-- Scott Kruger Tech-X Corporation [email protected] 5621 Arapahoe Ave, Suite A Phone: (720) 466-3196 Boulder, CO 80303 Fax: (303) 448-7756